Community Networks Co-op · est. 2009

Home › Forum › Marketplace › Topic

Selling surplus cable (CAT6, 300m)

Started 21 December 2018 · 1254 views

medwards
Posts: 184
Millbrook

The cabinet in Barrow Lane needs a new fan, it gets very hot in summer.

Could someone post the minutes? The link on the old page is broken.

robert3
Posts: 185
Highcross

This has been reported before, see the thread from 2015.

brian81
Posts: 479
St. Clement

Bumping this as it is still happening. I measured about 18 Mbps down and 6 up, which is normal for that sector.

cbrown
Posts: 630
Fenwick

Has anyone from the technical team had a look at this yet? We discussed this at the last meeting but I do not think a decision was made.

swood
Posts: 562
Old Harbour

The firmware on the Netgear R7000 is very old, there is a newer release on the vendor site. Lovely work on the new mast, the signal is much better now.

tedwards
Posts: 700
Northgate

The cabinet in Ashford Hill needs a new fan, it gets very hot in summer. Can confirm, same here since about 7pm.

cbrown
Posts: 630
Fenwick

Could someone post the minutes? The link on the old page is broken. The cabinet in Millbrook needs a new fan, it gets very hot in summer.

michael33
Posts: 887
Old Harbour

We are still looking for volunteers for the open day. Has anyone from the technical team had a look at this yet?

carol38
Posts: 467
Fenwick

This has been reported before, see the thread from 2013. Not sure this is the right board, mods feel free to move it.

nicola92
Posts: 21
Highcross

If you need a hand with the install, I am around most weekends. This has been reported before, see the thread from 2018.

lfernandes
Posts: 281
Riverside

Thanks, that fixed it for me. Marking as solved.

fhughes
Posts: 569
Old Harbour

This has been reported before, see the thread from 2012. I will raise it with the board on Tuesday. Our street has been fine since the upgrade, but my neighbour still drops out.

daniel21
Posts: 3
Riverside

I had the same issue last winter and it turned out to be the PoE injector. Could someone post the minutes? The link on the old page is broken. The firmware on the Yagi antenna is very old, there is a newer release on the vendor site.

helen98
Posts: 623
St. Clement

I measured about 18 Mbps down and 6 up, which is normal for that sector.

This topic is locked. Registrations are closed.