Mesh node config backup script

Started 12 February 2012 · 2678 views

dlindqvist
Posts: 314
Highcross

I can bring a ladder and a crimping tool if that helps. Good to see the forum is still alive! We are still looking for volunteers for the AGM.

I can bring a ladder and a crimping tool if that helps. If you need a hand with the install, I am around most weekends. The firmware on the Netgear R7000 is very old, there is a newer release on the vendor site.

joanna77
Posts: 842
Elmstead

We are still looking for volunteers for the cable pulling weekend. Has anyone from the technical team had a look at this yet?

ian96
Posts: 882
Fenwick

This has been reported before, see the thread from 2019. Please do not post account numbers on the forum, send them to the office instead. Can confirm, same here since about 7pm.

michael41
Posts: 511
St. Clement

The office phone goes to voicemail, is anyone still checking it? Bumping this as it is still happening. Has the billing system changed? My last invoice looked different.

thomas92
Posts: 350
Riverside

I can bring a ladder and a crimping tool if that helps. I will raise it with the board on Tuesday.

daniel25
Posts: 552
St. Clement

This has been reported before, see the thread from 2019. If you need a hand with the install, I am around most weekends.

lucia99
Posts: 286
Westmarsh

The firmware on the PoE injector is very old, there is a newer release on the vendor site.

lkowalski
Posts: 87
Ashford Hill

The Highcross relay was moved last year so the old coverage map is wrong. Please do not post account numbers on the forum, send them to the office instead.

nward
Posts: 517
Ashford Hill

I can bring a ladder and a crimping tool if that helps.

lucia99
Posts: 286
Westmarsh

Has the billing system changed? My last invoice looked different. Has anyone from the technical team had a look at this yet?

sandra85
Posts: 797
Highcross

We are still looking for volunteers for the spring install day. Our street has been fine since the upgrade, but my neighbour still drops out. Bumping this as it is still happening.

mnovak
Posts: 356
Old Harbour

The firmware on the Netgear R7000 is very old, there is a newer release on the vendor site. I measured about 18 Mbps down and 6 up, which is normal for that sector.

ikelly
Posts: 602
Old Harbour

Can confirm, same here since about 7pm. This has been reported before, see the thread from 2012. The firmware on the Raspberry Pi 3 is very old, there is a newer release on the vendor site.

agarcia
Posts: 85
Kingsley Park

Bumping this as it is still happening.

swood
Posts: 55
Northgate

I will raise it with the board on Tuesday.

This topic is locked. Registrations are closed.