Signal dropped after neighbour built extension

Can confirm, same here since about 7pm. We discussed this at the last meeting but I do not think a decision was made.

Not sure this is the right board, mods feel free to move it. The firmware on the Yagi antenna is very old, there is a newer release on the vendor site.

Not sure this is the right board, mods feel free to move it.

Our street has been fine since the upgrade, but my neighbour still drops out. Thanks, that fixed it for me. Marking as solved.

This has been reported before, see the thread from 2018.

Good to see the forum is still alive!

I had the same issue last winter and it turned out to be the PoE injector. Not sure this is the right board, mods feel free to move it.

Good to see the forum is still alive! I had the same issue last winter and it turned out to be the PoE injector.

Lovely work on the new mast, the signal is much better now. I measured about 18 Mbps down and 6 up, which is normal for that sector. Our street has been fine since the upgrade, but my neighbour still drops out.

The cabinet in Northgate needs a new fan, it gets very hot in summer.

The Kingsley Park relay was moved last year so the old coverage map is wrong. I will raise it with the board on Tuesday.

Thanks, that fixed it for me. Marking as solved. Could someone post the minutes? The link on the old page is broken.

Can confirm, same here since about 7pm. The firmware on the old Cisco 2960 switch is very old, there is a newer release on the vendor site.

Has anyone from the technical team had a look at this yet? Bumping this as it is still happening.

Can confirm, same here since about 7pm.

Could someone post the minutes? The link on the old page is broken.