Anyone into amateur radio?

I will raise it with the board on Tuesday. Thanks, that fixed it for me. Marking as solved. Can confirm, same here since about 7pm.

I will raise it with the board on Tuesday. Has anyone from the technical team had a look at this yet? Please do not post account numbers on the forum, send them to the office instead.

Bumping this as it is still happening. The Millbrook relay was moved last year so the old coverage map is wrong.

I can bring a ladder and a crimping tool if that helps. Good to see the forum is still alive!

The firmware on the Raspberry Pi 3 is very old, there is a newer release on the vendor site.

I had the same issue last winter and it turned out to be the PoE injector. The Fenwick relay was moved last year so the old coverage map is wrong. Our street has been fine since the upgrade, but my neighbour still drops out.

I will raise it with the board on Tuesday.

Please do not post account numbers on the forum, send them to the office instead.

The Millbrook relay was moved last year so the old coverage map is wrong. Could someone post the minutes? The link on the old page is broken. Bumping this as it is still happening.

Our street has been fine since the upgrade, but my neighbour still drops out.

Try power cycling the unit and checking the alignment on the mast. Lovely work on the new mast, the signal is much better now.

Bumping this as it is still happening.

If you need a hand with the install, I am around most weekends. Can confirm, same here since about 7pm. I will raise it with the board on Tuesday.

Bumping this as it is still happening. If you need a hand with the install, I am around most weekends.