FS: old Cisco 2960 switch, barely used

This has been reported before, see the thread from 2012. We are still looking for volunteers for the AGM.

This has been reported before, see the thread from 2013. Thanks, that fixed it for me. Marking as solved.

This has been reported before, see the thread from 2017. Not sure this is the right board, mods feel free to move it. I had the same issue last winter and it turned out to be the PoE injector.

Lovely work on the new mast, the signal is much better now.

Bumping this as it is still happening.

The cabinet in Ashford Hill needs a new fan, it gets very hot in summer. The firmware on the PoE injector is very old, there is a newer release on the vendor site. Bumping this as it is still happening.

Good to see the forum is still alive! This has been reported before, see the thread from 2011. Not sure this is the right board, mods feel free to move it.

Good to see the forum is still alive! Bumping this as it is still happening.

The Fenwick relay was moved last year so the old coverage map is wrong. We are still looking for volunteers for the open day.

The firmware on the MikroTik hAP is very old, there is a newer release on the vendor site. Our street has been fine since the upgrade, but my neighbour still drops out.

If you need a hand with the install, I am around most weekends.

Has anyone from the technical team had a look at this yet? This has been reported before, see the thread from 2014.

I measured about 18 Mbps down and 6 up, which is normal for that sector. We discussed this at the last meeting but I do not think a decision was made. Lovely work on the new mast, the signal is much better now.

Try power cycling the unit and checking the alignment on the mast. I will raise it with the board on Tuesday.

Could someone post the minutes? The link on the old page is broken. The cabinet in Northgate needs a new fan, it gets very hot in summer. The office phone goes to voicemail, is anyone still checking it?