Swap my MikroTik hAP for PoE switch

Has the billing system changed? My last invoice looked different. The firmware on the Yagi antenna is very old, there is a newer release on the vendor site.

This has been reported before, see the thread from 2014. Bumping this as it is still happening. Lovely work on the new mast, the signal is much better now.

The office phone goes to voicemail, is anyone still checking it? This has been reported before, see the thread from 2014. The firmware on the Raspberry Pi 3 is very old, there is a newer release on the vendor site.

Could someone post the minutes? The link on the old page is broken. I had the same issue last winter and it turned out to be the PoE injector. The cabinet in Millbrook needs a new fan, it gets very hot in summer.

I had the same issue last winter and it turned out to be the PoE injector.

Has anyone from the technical team had a look at this yet? Can confirm, same here since about 7pm. Not sure this is the right board, mods feel free to move it.

Try power cycling the unit and checking the alignment on the mast. We discussed this at the last meeting but I do not think a decision was made. If you need a hand with the install, I am around most weekends.