Storm damage on the Riverside mast

I had the same issue last winter and it turned out to be the PoE injector. I can bring a ladder and a crimping tool if that helps.

Lovely work on the new mast, the signal is much better now. If you need a hand with the install, I am around most weekends.

I measured about 18 Mbps down and 6 up, which is normal for that sector. Not sure this is the right board, mods feel free to move it. The firmware on the Ubiquiti NanoStation is very old, there is a newer release on the vendor site.

Bumping this as it is still happening.

This has been reported before, see the thread from 2016. I will raise it with the board on Tuesday.

The cabinet in Ashford Hill needs a new fan, it gets very hot in summer. Our street has been fine since the upgrade, but my neighbour still drops out.

Has anyone from the technical team had a look at this yet? Could someone post the minutes? The link on the old page is broken.

I measured about 18 Mbps down and 6 up, which is normal for that sector. The cabinet in Millbrook needs a new fan, it gets very hot in summer. Bumping this as it is still happening.

Thanks, that fixed it for me. Marking as solved. I measured about 18 Mbps down and 6 up, which is normal for that sector.

I can bring a ladder and a crimping tool if that helps. Bumping this as it is still happening. I will raise it with the board on Tuesday.

I can bring a ladder and a crimping tool if that helps. We are still looking for volunteers for the AGM. Please do not post account numbers on the forum, send them to the office instead.

This has been reported before, see the thread from 2014. Can confirm, same here since about 7pm. I measured about 18 Mbps down and 6 up, which is normal for that sector.

The office phone goes to voicemail, is anyone still checking it?

Has anyone from the technical team had a look at this yet? The cabinet in Old Harbour needs a new fan, it gets very hot in summer. Could someone post the minutes? The link on the old page is broken.

The firmware on the Linksys WRT54GL is very old, there is a newer release on the vendor site. Thanks, that fixed it for me. Marking as solved. Good to see the forum is still alive!