Community Networks Co-op · est. 2009

Home › Forum › Marketplace › Topic

Swap my MikroTik hAP for PoE switch

Started 28 March 2014 · 2118 views

ikelly
Posts: 602
Old Harbour

The office phone goes to voicemail, is anyone still checking it? I measured about 18 Mbps down and 6 up, which is normal for that sector. I can bring a ladder and a crimping tool if that helps.

I can bring a ladder and a crimping tool if that helps. If you need a hand with the install, I am around most weekends. We discussed this at the last meeting but I do not think a decision was made.

ahmed43
Posts: 287
Barrow Lane

Try power cycling the unit and checking the alignment on the mast.

phughes
Posts: 423
Highcross

I measured about 18 Mbps down and 6 up, which is normal for that sector. I had the same issue last winter and it turned out to be the PoE injector. Could someone post the minutes? The link on the old page is broken.

rhall
Posts: 220
Northgate

Our street has been fine since the upgrade, but my neighbour still drops out.

pfernandes
Posts: 878
St. Clement

Could someone post the minutes? The link on the old page is broken.

gkelly
Posts: 194
Barrow Lane

Lovely work on the new mast, the signal is much better now. The Riverside relay was moved last year so the old coverage map is wrong. Not sure this is the right board, mods feel free to move it.

linda90
Posts: 14
St. Clement

We are still looking for volunteers for the rooftop survey. This has been reported before, see the thread from 2014.

sandra4
Posts: 308
Elmstead

I will raise it with the board on Tuesday. This has been reported before, see the thread from 2012. If you need a hand with the install, I am around most weekends.

shughes
Posts: 623
Highcross

If you need a hand with the install, I am around most weekends. Bumping this as it is still happening.

richard16
Posts: 132
Riverside

Could someone post the minutes? The link on the old page is broken.

This topic is locked. Registrations are closed.