Community Networks Co-op · est. 2009

Home › Forum › General Discussion › Topic

Question about voting at the AGM

Started 22 September 2014 · 241 views

daniel21
Posts: 3
Riverside

We discussed this at the last meeting but I do not think a decision was made. Try power cycling the unit and checking the alignment on the mast.

I can bring a ladder and a crimping tool if that helps. Lovely work on the new mast, the signal is much better now.

mcooper
Posts: 33
Kingsley Park

I measured about 18 Mbps down and 6 up, which is normal for that sector.

jhall
Posts: 177
St. Clement

I measured about 18 Mbps down and 6 up, which is normal for that sector.

nkowalski
Posts: 489
Northgate

Thanks, that fixed it for me. Marking as solved.

hcooper
Posts: 876
Riverside

The cabinet in Old Harbour needs a new fan, it gets very hot in summer. Lovely work on the new mast, the signal is much better now. Has the billing system changed? My last invoice looked different.

pbennett
Posts: 628
Old Harbour

Can confirm, same here since about 7pm. The cabinet in Old Harbour needs a new fan, it gets very hot in summer. The cabinet in Millbrook needs a new fan, it gets very hot in summer.

claire56
Posts: 120
Ashford Hill

Has the billing system changed? My last invoice looked different.

linda90
Posts: 14
St. Clement

The Kingsley Park relay was moved last year so the old coverage map is wrong. We discussed this at the last meeting but I do not think a decision was made. Has anyone from the technical team had a look at this yet?

lucia99
Posts: 286
Westmarsh

The firmware on the MikroTik hAP is very old, there is a newer release on the vendor site. I will raise it with the board on Tuesday.

This topic is locked. Registrations are closed.