Swap my Ubiquiti NanoStation for PoE switch

The cabinet in Northgate needs a new fan, it gets very hot in summer. Bumping this as it is still happening.

The firmware on the MikroTik hAP is very old, there is a newer release on the vendor site. Lovely work on the new mast, the signal is much better now.

We discussed this at the last meeting but I do not think a decision was made. I will raise it with the board on Tuesday.

Thanks, that fixed it for me. Marking as solved. Has anyone from the technical team had a look at this yet?

I will raise it with the board on Tuesday.

The office phone goes to voicemail, is anyone still checking it?

Has the billing system changed? My last invoice looked different. I had the same issue last winter and it turned out to be the PoE injector.

Try power cycling the unit and checking the alignment on the mast. Good to see the forum is still alive! Has anyone from the technical team had a look at this yet?

Thanks, that fixed it for me. Marking as solved. This has been reported before, see the thread from 2018.

I can bring a ladder and a crimping tool if that helps. Not sure this is the right board, mods feel free to move it. Try power cycling the unit and checking the alignment on the mast.

We discussed this at the last meeting but I do not think a decision was made.

Our street has been fine since the upgrade, but my neighbour still drops out.

Thanks, that fixed it for me. Marking as solved. Could someone post the minutes? The link on the old page is broken. I will raise it with the board on Tuesday.

Could someone post the minutes? The link on the old page is broken. I had the same issue last winter and it turned out to be the PoE injector.