Who looks after the Northgate relay?

Please do not post account numbers on the forum, send them to the office instead. The firmware on the Linksys WRT54GL is very old, there is a newer release on the vendor site.

I will raise it with the board on Tuesday. I had the same issue last winter and it turned out to be the PoE injector.

Could someone post the minutes? The link on the old page is broken. Bumping this as it is still happening. The firmware on the old Cisco 2960 switch is very old, there is a newer release on the vendor site.

Try power cycling the unit and checking the alignment on the mast. Lovely work on the new mast, the signal is much better now. Bumping this as it is still happening.

Bumping this as it is still happening. Has anyone from the technical team had a look at this yet? Lovely work on the new mast, the signal is much better now.

Lovely work on the new mast, the signal is much better now. The Highcross relay was moved last year so the old coverage map is wrong. This has been reported before, see the thread from 2017.

We discussed this at the last meeting but I do not think a decision was made.

The firmware on the old Cisco 2960 switch is very old, there is a newer release on the vendor site. The Westmarsh relay was moved last year so the old coverage map is wrong. If you need a hand with the install, I am around most weekends.