Anyone into amateur radio?

Started 18 May 2013 · 257 views

aokafor
Posts: 79
Northgate

Good to see the forum is still alive! Has anyone from the technical team had a look at this yet?

Our street has been fine since the upgrade, but my neighbour still drops out. Not sure this is the right board, mods feel free to move it.

mlindqvist
Posts: 879
Ashford Hill

Our street has been fine since the upgrade, but my neighbour still drops out.

smorgan
Posts: 834
Old Harbour

Not sure this is the right board, mods feel free to move it. The firmware on the Yagi antenna is very old, there is a newer release on the vendor site. Try power cycling the unit and checking the alignment on the mast.

alison35
Posts: 159
Barrow Lane

I measured about 18 Mbps down and 6 up, which is normal for that sector. We are still looking for volunteers for the AGM. Lovely work on the new mast, the signal is much better now.

lwood
Posts: 504
Riverside

I had the same issue last winter and it turned out to be the PoE injector. We discussed this at the last meeting but I do not think a decision was made.

hannah60
Posts: 705
Ashford Hill

This has been reported before, see the thread from 2015. Has anyone from the technical team had a look at this yet?

priya98
Posts: 682
Kingsley Park

Try power cycling the unit and checking the alignment on the mast. Has anyone from the technical team had a look at this yet? I can bring a ladder and a crimping tool if that helps.

This topic is locked. Registrations are closed.