Signal dropped after neighbour built extension

I measured about 18 Mbps down and 6 up, which is normal for that sector. Thanks, that fixed it for me. Marking as solved.

The firmware on the Ubiquiti NanoStation is very old, there is a newer release on the vendor site. The office phone goes to voicemail, is anyone still checking it?

I measured about 18 Mbps down and 6 up, which is normal for that sector.

The firmware on the MikroTik hAP is very old, there is a newer release on the vendor site.

Bumping this as it is still happening. Good to see the forum is still alive!

The firmware on the old Cisco 2960 switch is very old, there is a newer release on the vendor site. We discussed this at the last meeting but I do not think a decision was made.

I can bring a ladder and a crimping tool if that helps. Has anyone from the technical team had a look at this yet?

The firmware on the UPS (APC 1500) is very old, there is a newer release on the vendor site.

We are still looking for volunteers for the AGM.

The Fenwick relay was moved last year so the old coverage map is wrong. I will raise it with the board on Tuesday.

I had the same issue last winter and it turned out to be the PoE injector. Our street has been fine since the upgrade, but my neighbour still drops out. If you need a hand with the install, I am around most weekends.

Can confirm, same here since about 7pm. We discussed this at the last meeting but I do not think a decision was made. Lovely work on the new mast, the signal is much better now.

Bumping this as it is still happening. Has the billing system changed? My last invoice looked different.

I had the same issue last winter and it turned out to be the PoE injector. Thanks, that fixed it for me. Marking as solved.