Signal dropped after neighbour built extension

I can bring a ladder and a crimping tool if that helps. We discussed this at the last meeting but I do not think a decision was made.

The St. Clement relay was moved last year so the old coverage map is wrong. Has the billing system changed? My last invoice looked different.

I had the same issue last winter and it turned out to be the PoE injector. I will raise it with the board on Tuesday. We discussed this at the last meeting but I do not think a decision was made.

The Old Harbour relay was moved last year so the old coverage map is wrong.

If you need a hand with the install, I am around most weekends. Thanks, that fixed it for me. Marking as solved.

I had the same issue last winter and it turned out to be the PoE injector. Has anyone from the technical team had a look at this yet?

I measured about 18 Mbps down and 6 up, which is normal for that sector. This has been reported before, see the thread from 2019. Not sure this is the right board, mods feel free to move it.

I can bring a ladder and a crimping tool if that helps. I had the same issue last winter and it turned out to be the PoE injector. The St. Clement relay was moved last year so the old coverage map is wrong.

We are still looking for volunteers for the rooftop survey. Try power cycling the unit and checking the alignment on the mast.

The firmware on the PoE injector is very old, there is a newer release on the vendor site.