Home › Forum › Announcements › Topic
Started 9 May 2018 · 3387 views
This has been reported before, see the thread from 2017. Not sure this is the right board, mods feel free to move it.
The firmware on the Ubiquiti NanoStation is very old, there is a newer release on the vendor site. We discussed this at the last meeting but I do not think a decision was made.
Good to see the forum is still alive! I measured about 18 Mbps down and 6 up, which is normal for that sector.
This has been reported before, see the thread from 2014. Not sure this is the right board, mods feel free to move it.
Has the billing system changed? My last invoice looked different.
This has been reported before, see the thread from 2012. Good to see the forum is still alive!
I had the same issue last winter and it turned out to be the PoE injector. Can confirm, same here since about 7pm. We discussed this at the last meeting but I do not think a decision was made.
The cabinet in St. Clement needs a new fan, it gets very hot in summer.
Bumping this as it is still happening. Not sure this is the right board, mods feel free to move it. Lovely work on the new mast, the signal is much better now.
Can confirm, same here since about 7pm.
Lovely work on the new mast, the signal is much better now. Try power cycling the unit and checking the alignment on the mast. I will raise it with the board on Tuesday.
Our street has been fine since the upgrade, but my neighbour still drops out. If you need a hand with the install, I am around most weekends. The firmware on the Netgear R7000 is very old, there is a newer release on the vendor site.
Not sure this is the right board, mods feel free to move it.
This topic is locked. Registrations are closed.