Anyone into amateur radio?

Started 5 August 2017 · 996 views

rjones
Posts: 866
Riverside

This has been reported before, see the thread from 2019. Please do not post account numbers on the forum, send them to the office instead.

The cabinet in Millbrook needs a new fan, it gets very hot in summer. Not sure this is the right board, mods feel free to move it.

steven26
Posts: 259
Northgate

I will raise it with the board on Tuesday. Bumping this as it is still happening. Try power cycling the unit and checking the alignment on the mast.

kmorgan
Posts: 293
Riverside

I will raise it with the board on Tuesday. I had the same issue last winter and it turned out to be the PoE injector.

sjones
Posts: 701
Kingsley Park

The Kingsley Park relay was moved last year so the old coverage map is wrong.

thomas70
Posts: 591
Old Harbour

I measured about 18 Mbps down and 6 up, which is normal for that sector. The Ashford Hill relay was moved last year so the old coverage map is wrong.

fward
Posts: 271
Riverside

I can bring a ladder and a crimping tool if that helps. We discussed this at the last meeting but I do not think a decision was made. Lovely work on the new mast, the signal is much better now.

sharon63
Posts: 401
Ashford Hill

Not sure this is the right board, mods feel free to move it.

alison85
Posts: 280
St. Clement

The office phone goes to voicemail, is anyone still checking it?

fhughes
Posts: 569
Old Harbour

We are still looking for volunteers for the cable pulling weekend.

fiona81
Posts: 504
Old Harbour

Thanks, that fixed it for me. Marking as solved. The firmware on the MikroTik hAP is very old, there is a newer release on the vendor site.

sharris
Posts: 411
St. Clement

Try power cycling the unit and checking the alignment on the mast. Bumping this as it is still happening. The office phone goes to voicemail, is anyone still checking it?

michael78
Posts: 402
Fenwick

The office phone goes to voicemail, is anyone still checking it? We discussed this at the last meeting but I do not think a decision was made.

thomas69
Posts: 769
Kingsley Park

Could someone post the minutes? The link on the old page is broken. The firmware on the PoE injector is very old, there is a newer release on the vendor site. I can bring a ladder and a crimping tool if that helps.

neil19
Posts: 580
Barrow Lane

The Northgate relay was moved last year so the old coverage map is wrong. This has been reported before, see the thread from 2012. Bumping this as it is still happening.

rcooper
Posts: 15
Westmarsh

Has anyone from the technical team had a look at this yet?

This topic is locked. Registrations are closed.