Best antenna for Riverside?

Started 20 July 2016 · 3378 views

graham96
Posts: 395
Westmarsh

I had the same issue last winter and it turned out to be the PoE injector. Lovely work on the new mast, the signal is much better now. Can confirm, same here since about 7pm.

The cabinet in Barrow Lane needs a new fan, it gets very hot in summer. Not sure this is the right board, mods feel free to move it. Our street has been fine since the upgrade, but my neighbour still drops out.

gbennett
Posts: 277
Fenwick

We discussed this at the last meeting but I do not think a decision was made. The cabinet in St. Clement needs a new fan, it gets very hot in summer.

cwood
Posts: 531
St. Clement

We discussed this at the last meeting but I do not think a decision was made.

lmurphy
Posts: 563
Old Harbour

This has been reported before, see the thread from 2019. I can bring a ladder and a crimping tool if that helps. This has been reported before, see the thread from 2013.

sandra4
Posts: 308
Elmstead

I measured about 18 Mbps down and 6 up, which is normal for that sector. Thanks, that fixed it for me. Marking as solved. Try power cycling the unit and checking the alignment on the mast.

peter26
Posts: 152
St. Clement

I will raise it with the board on Tuesday. The cabinet in Ashford Hill needs a new fan, it gets very hot in summer.

ggreen
Posts: 450
Ashford Hill

The firmware on the Netgear R7000 is very old, there is a newer release on the vendor site. I can bring a ladder and a crimping tool if that helps. This has been reported before, see the thread from 2019.

mark4
Posts: 474
Ashford Hill

The cabinet in Riverside needs a new fan, it gets very hot in summer. Not sure this is the right board, mods feel free to move it. I had the same issue last winter and it turned out to be the PoE injector.

mnovak
Posts: 356
Old Harbour

I can bring a ladder and a crimping tool if that helps.

lfernandes
Posts: 281
Riverside

Has the billing system changed? My last invoice looked different.

thomas69
Posts: 769
Kingsley Park

I can bring a ladder and a crimping tool if that helps. The Westmarsh relay was moved last year so the old coverage map is wrong.

paul62
Posts: 253
Old Harbour

Good to see the forum is still alive! The Kingsley Park relay was moved last year so the old coverage map is wrong.

peter38
Posts: 828
Westmarsh

Has anyone from the technical team had a look at this yet? I can bring a ladder and a crimping tool if that helps. Could someone post the minutes? The link on the old page is broken.

dlindqvist
Posts: 314
Highcross

The firmware on the Raspberry Pi 3 is very old, there is a newer release on the vendor site. Lovely work on the new mast, the signal is much better now.

ahmed43
Posts: 287
Barrow Lane

I had the same issue last winter and it turned out to be the PoE injector. Try power cycling the unit and checking the alignment on the mast.

This topic is locked. Registrations are closed.