Free to collect: Ubiquiti NanoStation

Thanks, that fixed it for me. Marking as solved. Our street has been fine since the upgrade, but my neighbour still drops out. I can bring a ladder and a crimping tool if that helps.

I measured about 18 Mbps down and 6 up, which is normal for that sector. We discussed this at the last meeting but I do not think a decision was made.

Try power cycling the unit and checking the alignment on the mast. I measured about 18 Mbps down and 6 up, which is normal for that sector. If you need a hand with the install, I am around most weekends.

Try power cycling the unit and checking the alignment on the mast. We are still looking for volunteers for the cable pulling weekend.

The cabinet in St. Clement needs a new fan, it gets very hot in summer. Has anyone from the technical team had a look at this yet?

Bumping this as it is still happening.

Lovely work on the new mast, the signal is much better now. Bumping this as it is still happening.

Could someone post the minutes? The link on the old page is broken. Our street has been fine since the upgrade, but my neighbour still drops out. The firmware on the Ubiquiti NanoStation is very old, there is a newer release on the vendor site.

Good to see the forum is still alive! Has anyone from the technical team had a look at this yet?

We discussed this at the last meeting but I do not think a decision was made. Thanks, that fixed it for me. Marking as solved.

Bumping this as it is still happening. We are still looking for volunteers for the cable pulling weekend. If you need a hand with the install, I am around most weekends.

Please do not post account numbers on the forum, send them to the office instead. Lovely work on the new mast, the signal is much better now. I can bring a ladder and a crimping tool if that helps.

Thanks, that fixed it for me. Marking as solved. The firmware on the Linksys WRT54GL is very old, there is a newer release on the vendor site.

The cabinet in Elmstead needs a new fan, it gets very hot in summer. We are still looking for volunteers for the AGM.

Bumping this as it is still happening. This has been reported before, see the thread from 2019. Has anyone from the technical team had a look at this yet?

The firmware on the PoE injector is very old, there is a newer release on the vendor site. Thanks, that fixed it for me. Marking as solved. We are still looking for volunteers for the open day.