Community Networks Co-op · est. 2009

Home › Forum › Off-topic › Topic

Pub quiz team this Thursday?

Started 22 February 2013 · 2070 views

rfernandes
Posts: 637
Elmstead

I can bring a ladder and a crimping tool if that helps. I measured about 18 Mbps down and 6 up, which is normal for that sector. Can confirm, same here since about 7pm.

The cabinet in Northgate needs a new fan, it gets very hot in summer. I can bring a ladder and a crimping tool if that helps. The office phone goes to voicemail, is anyone still checking it?

peter38
Posts: 828
Westmarsh

The cabinet in Fenwick needs a new fan, it gets very hot in summer. I measured about 18 Mbps down and 6 up, which is normal for that sector. Has the billing system changed? My last invoice looked different.

dmorris
Posts: 627
Ashford Hill

Bumping this as it is still happening. Has the billing system changed? My last invoice looked different. I will raise it with the board on Tuesday.

fharris
Posts: 45
Westmarsh

Can confirm, same here since about 7pm. Has the billing system changed? My last invoice looked different. I had the same issue last winter and it turned out to be the PoE injector.

martin22
Posts: 289
Barrow Lane

I measured about 18 Mbps down and 6 up, which is normal for that sector.

peter38
Posts: 828
Westmarsh

Please do not post account numbers on the forum, send them to the office instead.

eharris
Posts: 515
Old Harbour

I had the same issue last winter and it turned out to be the PoE injector. Could someone post the minutes? The link on the old page is broken. Bumping this as it is still happening.

sclarke
Posts: 83
Old Harbour

If you need a hand with the install, I am around most weekends. The firmware on the Netgear R7000 is very old, there is a newer release on the vendor site.

brian36
Posts: 256
Northgate

Try power cycling the unit and checking the alignment on the mast. I measured about 18 Mbps down and 6 up, which is normal for that sector.

kjones
Posts: 851
Fenwick

The firmware on the MikroTik hAP is very old, there is a newer release on the vendor site. Could someone post the minutes? The link on the old page is broken.

This topic is locked. Registrations are closed.