Anyone into amateur radio?

I will raise it with the board on Tuesday.

Thanks, that fixed it for me. Marking as solved.

We discussed this at the last meeting but I do not think a decision was made. Thanks, that fixed it for me. Marking as solved. If you need a hand with the install, I am around most weekends.

The Ashford Hill relay was moved last year so the old coverage map is wrong. Thanks, that fixed it for me. Marking as solved. Bumping this as it is still happening.

I will raise it with the board on Tuesday. Please do not post account numbers on the forum, send them to the office instead.

Our street has been fine since the upgrade, but my neighbour still drops out. Not sure this is the right board, mods feel free to move it.

Not sure this is the right board, mods feel free to move it.

Bumping this as it is still happening. I measured about 18 Mbps down and 6 up, which is normal for that sector.

Has anyone from the technical team had a look at this yet?

Could someone post the minutes? The link on the old page is broken. Has anyone from the technical team had a look at this yet? The firmware on the TP-Link CPE510 is very old, there is a newer release on the vendor site.

I can bring a ladder and a crimping tool if that helps.

Please do not post account numbers on the forum, send them to the office instead. The firmware on the UPS (APC 1500) is very old, there is a newer release on the vendor site.

Thanks, that fixed it for me. Marking as solved. This has been reported before, see the thread from 2019.

Lovely work on the new mast, the signal is much better now. This has been reported before, see the thread from 2018.

We are still looking for volunteers for the cable pulling weekend. Good to see the forum is still alive!