Community Networks Co-op · est. 2009

Home › Forum › General Discussion › Topic

Question about voting at the AGM

Started 24 May 2017 · 1892 views

cokafor
Posts: 68
Barrow Lane

The office phone goes to voicemail, is anyone still checking it? I can bring a ladder and a crimping tool if that helps.

The St. Clement relay was moved last year so the old coverage map is wrong. Try power cycling the unit and checking the alignment on the mast.

robert8
Posts: 626
St. Clement

The cabinet in Barrow Lane needs a new fan, it gets very hot in summer. If you need a hand with the install, I am around most weekends. I will raise it with the board on Tuesday.

nward
Posts: 517
Ashford Hill

Thanks, that fixed it for me. Marking as solved. Not sure this is the right board, mods feel free to move it. Has anyone from the technical team had a look at this yet?

mthompson
Posts: 366
Barrow Lane

The cabinet in Riverside needs a new fan, it gets very hot in summer. Not sure this is the right board, mods feel free to move it.

nicola14
Posts: 204
Westmarsh

Can confirm, same here since about 7pm.

eharris
Posts: 515
Old Harbour

I can bring a ladder and a crimping tool if that helps. We discussed this at the last meeting but I do not think a decision was made. I will raise it with the board on Tuesday.

kbrown
Posts: 267
Highcross

Good to see the forum is still alive! Not sure this is the right board, mods feel free to move it.

marta2
Posts: 179
Barrow Lane

The cabinet in Northgate needs a new fan, it gets very hot in summer. I can bring a ladder and a crimping tool if that helps. The cabinet in Elmstead needs a new fan, it gets very hot in summer.

lpatel
Posts: 42
Elmstead

Not sure this is the right board, mods feel free to move it.

dwhite
Posts: 491
Highcross

We are still looking for volunteers for the open day.

shall
Posts: 633
Ashford Hill

If you need a hand with the install, I am around most weekends. I can bring a ladder and a crimping tool if that helps. Lovely work on the new mast, the signal is much better now.

cwood
Posts: 531
St. Clement

I measured about 18 Mbps down and 6 up, which is normal for that sector. We are still looking for volunteers for the cable pulling weekend.

rroberts
Posts: 21
Fenwick

Good to see the forum is still alive! The firmware on the PoE injector is very old, there is a newer release on the vendor site.

laura62
Posts: 489
Riverside

Bumping this as it is still happening.

This topic is locked. Registrations are closed.