Community Networks Co-op · est. 2009

Home › Forum › Outages & Maintenance › Topic

Power cut took down the Fenwick cabinet

Started 22 February 2019 · 3007 views

peter58
Posts: 621
Riverside

The office phone goes to voicemail, is anyone still checking it? Thanks, that fixed it for me. Marking as solved. The Riverside relay was moved last year so the old coverage map is wrong.

We are still looking for volunteers for the rooftop survey. The cabinet in Westmarsh needs a new fan, it gets very hot in summer. We are still looking for volunteers for the cable pulling weekend.

thomas70
Posts: 591
Old Harbour

The firmware on the Yagi antenna is very old, there is a newer release on the vendor site. Good to see the forum is still alive!

swilson
Posts: 264
Old Harbour

I measured about 18 Mbps down and 6 up, which is normal for that sector. This has been reported before, see the thread from 2014. We discussed this at the last meeting but I do not think a decision was made.

gary95
Posts: 82
Westmarsh

If you need a hand with the install, I am around most weekends. This has been reported before, see the thread from 2014.

linda90
Posts: 14
St. Clement

We discussed this at the last meeting but I do not think a decision was made. I had the same issue last winter and it turned out to be the PoE injector.

trobinson
Posts: 418
Riverside

Has the billing system changed? My last invoice looked different. Try power cycling the unit and checking the alignment on the mast. Bumping this as it is still happening.

laura62
Posts: 489
Riverside

If you need a hand with the install, I am around most weekends.

gary76
Posts: 501
Fenwick

The Ashford Hill relay was moved last year so the old coverage map is wrong. Please do not post account numbers on the forum, send them to the office instead.

martin2
Posts: 251
Millbrook

Bumping this as it is still happening. This has been reported before, see the thread from 2013. Lovely work on the new mast, the signal is much better now.

kjones
Posts: 851
Fenwick

The firmware on the TP-Link CPE510 is very old, there is a newer release on the vendor site. I will raise it with the board on Tuesday.

ingrid69
Posts: 150
St. Clement

The office phone goes to voicemail, is anyone still checking it? We are still looking for volunteers for the AGM.

kbrown
Posts: 267
Highcross

Has anyone from the technical team had a look at this yet?

dgarcia
Posts: 397
Riverside

I had the same issue last winter and it turned out to be the PoE injector. Not sure this is the right board, mods feel free to move it.

lkowalski
Posts: 87
Ashford Hill

Good to see the forum is still alive!

This topic is locked. Registrations are closed.