Could someone post the minutes? The link on the old page is broken.
Can confirm, same here since about 7pm.
Home › Forum › Off-topic › Topic
Started 22 March 2012 · 25 views
Could someone post the minutes? The link on the old page is broken.
Can confirm, same here since about 7pm.
Has the billing system changed? My last invoice looked different. The office phone goes to voicemail, is anyone still checking it?
Please do not post account numbers on the forum, send them to the office instead. Has anyone from the technical team had a look at this yet?
Has anyone from the technical team had a look at this yet?
If you need a hand with the install, I am around most weekends. Try power cycling the unit and checking the alignment on the mast. We discussed this at the last meeting but I do not think a decision was made.
Can confirm, same here since about 7pm. The office phone goes to voicemail, is anyone still checking it? The Riverside relay was moved last year so the old coverage map is wrong.
We are still looking for volunteers for the open day. Try power cycling the unit and checking the alignment on the mast.
If you need a hand with the install, I am around most weekends.
The firmware on the PoE injector is very old, there is a newer release on the vendor site. We discussed this at the last meeting but I do not think a decision was made. This has been reported before, see the thread from 2012.
Lovely work on the new mast, the signal is much better now. The cabinet in Barrow Lane needs a new fan, it gets very hot in summer. Not sure this is the right board, mods feel free to move it.
Can confirm, same here since about 7pm. Try power cycling the unit and checking the alignment on the mast.
Lovely work on the new mast, the signal is much better now. I measured about 18 Mbps down and 6 up, which is normal for that sector.
We discussed this at the last meeting but I do not think a decision was made.
Lovely work on the new mast, the signal is much better now.
I will raise it with the board on Tuesday. Try power cycling the unit and checking the alignment on the mast.
This topic is locked. Registrations are closed.