Coverage map out of date?

Try power cycling the unit and checking the alignment on the mast.

I had the same issue last winter and it turned out to be the PoE injector.

We are still looking for volunteers for the rooftop survey.

Bumping this as it is still happening. I had the same issue last winter and it turned out to be the PoE injector. Not sure this is the right board, mods feel free to move it.

The firmware on the old Cisco 2960 switch is very old, there is a newer release on the vendor site. Could someone post the minutes? The link on the old page is broken. The cabinet in Elmstead needs a new fan, it gets very hot in summer.

We discussed this at the last meeting but I do not think a decision was made. Has anyone from the technical team had a look at this yet?

If you need a hand with the install, I am around most weekends.

Lovely work on the new mast, the signal is much better now. Has the billing system changed? My last invoice looked different. Could someone post the minutes? The link on the old page is broken.

Has the billing system changed? My last invoice looked different.

Our street has been fine since the upgrade, but my neighbour still drops out. I measured about 18 Mbps down and 6 up, which is normal for that sector.

Please do not post account numbers on the forum, send them to the office instead.

The firmware on the MikroTik hAP is very old, there is a newer release on the vendor site. Try power cycling the unit and checking the alignment on the mast. Has anyone from the technical team had a look at this yet?