Community Networks Co-op · est. 2009

Home › Forum › General Discussion › Topic

Ideas for the open day

Started 2 June 2019 · 3429 views

daniel21
Posts: 3
Riverside

Can confirm, same here since about 7pm.

Thanks, that fixed it for me. Marking as solved.

martin75
Posts: 603
Ashford Hill

If you need a hand with the install, I am around most weekends. I will raise it with the board on Tuesday.

alison85
Posts: 280
St. Clement

The Old Harbour relay was moved last year so the old coverage map is wrong.

mary36
Posts: 160
Elmstead

Could someone post the minutes? The link on the old page is broken. The office phone goes to voicemail, is anyone still checking it?

mthompson
Posts: 366
Barrow Lane

If you need a hand with the install, I am around most weekends. Our street has been fine since the upgrade, but my neighbour still drops out. Good to see the forum is still alive!

ian92
Posts: 635
Riverside

Good to see the forum is still alive! The office phone goes to voicemail, is anyone still checking it?

karen91
Posts: 594
Riverside

I measured about 18 Mbps down and 6 up, which is normal for that sector. We discussed this at the last meeting but I do not think a decision was made. Could someone post the minutes? The link on the old page is broken.

linda5
Posts: 236
Barrow Lane

Good to see the forum is still alive! Could someone post the minutes? The link on the old page is broken. Lovely work on the new mast, the signal is much better now.

gary76
Posts: 501
Fenwick

Has anyone from the technical team had a look at this yet?

thomas69
Posts: 769
Kingsley Park

The firmware on the Netgear R7000 is very old, there is a newer release on the vendor site.

tomasz51
Posts: 507
Barrow Lane

I had the same issue last winter and it turned out to be the PoE injector.

ruth99
Posts: 210
Highcross

We discussed this at the last meeting but I do not think a decision was made. Good to see the forum is still alive!

This topic is locked. Registrations are closed.