FS: Yagi antenna, barely used

Please do not post account numbers on the forum, send them to the office instead. Has anyone from the technical team had a look at this yet?

I will raise it with the board on Tuesday. Not sure this is the right board, mods feel free to move it.

Try power cycling the unit and checking the alignment on the mast. We are still looking for volunteers for the cable pulling weekend. Thanks, that fixed it for me. Marking as solved.

The cabinet in Highcross needs a new fan, it gets very hot in summer. If you need a hand with the install, I am around most weekends. I measured about 18 Mbps down and 6 up, which is normal for that sector.

This has been reported before, see the thread from 2011. Please do not post account numbers on the forum, send them to the office instead.

Has anyone from the technical team had a look at this yet?

Good to see the forum is still alive! I measured about 18 Mbps down and 6 up, which is normal for that sector.

The firmware on the Raspberry Pi 3 is very old, there is a newer release on the vendor site. Try power cycling the unit and checking the alignment on the mast.

I had the same issue last winter and it turned out to be the PoE injector. Thanks, that fixed it for me. Marking as solved. We discussed this at the last meeting but I do not think a decision was made.