TP-Link CPE510 keeps rebooting after firmware update

I measured about 18 Mbps down and 6 up, which is normal for that sector. The cabinet in Kingsley Park needs a new fan, it gets very hot in summer. Can confirm, same here since about 7pm.

Please do not post account numbers on the forum, send them to the office instead. Bumping this as it is still happening. Has anyone from the technical team had a look at this yet?

We are still looking for volunteers for the summer fair stand.

The office phone goes to voicemail, is anyone still checking it?

Could someone post the minutes? The link on the old page is broken. This has been reported before, see the thread from 2018. We are still looking for volunteers for the cable pulling weekend.

Could someone post the minutes? The link on the old page is broken. The Fenwick relay was moved last year so the old coverage map is wrong.

Try power cycling the unit and checking the alignment on the mast. The firmware on the MikroTik hAP is very old, there is a newer release on the vendor site. Could someone post the minutes? The link on the old page is broken.

I had the same issue last winter and it turned out to be the PoE injector. The office phone goes to voicemail, is anyone still checking it? The Millbrook relay was moved last year so the old coverage map is wrong.

Can confirm, same here since about 7pm.

I can bring a ladder and a crimping tool if that helps.

Please do not post account numbers on the forum, send them to the office instead. The cabinet in Westmarsh needs a new fan, it gets very hot in summer. I can bring a ladder and a crimping tool if that helps.

Lovely work on the new mast, the signal is much better now.

Try power cycling the unit and checking the alignment on the mast. I had the same issue last winter and it turned out to be the PoE injector.

I measured about 18 Mbps down and 6 up, which is normal for that sector. Lovely work on the new mast, the signal is much better now.

If you need a hand with the install, I am around most weekends.

If you need a hand with the install, I am around most weekends. I had the same issue last winter and it turned out to be the PoE injector. Good to see the forum is still alive!