Latency spikes to the Ashford Hill hub

I measured about 18 Mbps down and 6 up, which is normal for that sector. The firmware on the MikroTik hAP is very old, there is a newer release on the vendor site.

Lovely work on the new mast, the signal is much better now. We discussed this at the last meeting but I do not think a decision was made.

Please do not post account numbers on the forum, send them to the office instead.

We are still looking for volunteers for the spring install day. Bumping this as it is still happening.

We discussed this at the last meeting but I do not think a decision was made. The Millbrook relay was moved last year so the old coverage map is wrong.

Thanks, that fixed it for me. Marking as solved. The firmware on the Netgear R7000 is very old, there is a newer release on the vendor site. We are still looking for volunteers for the cable pulling weekend.

The office phone goes to voicemail, is anyone still checking it? Not sure this is the right board, mods feel free to move it.

The firmware on the Netgear R7000 is very old, there is a newer release on the vendor site. Try power cycling the unit and checking the alignment on the mast. Bumping this as it is still happening.

Thanks, that fixed it for me. Marking as solved. I had the same issue last winter and it turned out to be the PoE injector. Has the billing system changed? My last invoice looked different.