Free to collect: Linksys WRT54GL

We discussed this at the last meeting but I do not think a decision was made. Thanks, that fixed it for me. Marking as solved.

Try power cycling the unit and checking the alignment on the mast. Has anyone from the technical team had a look at this yet? I will raise it with the board on Tuesday.

Lovely work on the new mast, the signal is much better now. Bumping this as it is still happening. I can bring a ladder and a crimping tool if that helps.

Could someone post the minutes? The link on the old page is broken. Not sure this is the right board, mods feel free to move it.

Bumping this as it is still happening.

Good to see the forum is still alive! The firmware on the MikroTik hAP is very old, there is a newer release on the vendor site. This has been reported before, see the thread from 2012.

I measured about 18 Mbps down and 6 up, which is normal for that sector.

Bumping this as it is still happening.

I measured about 18 Mbps down and 6 up, which is normal for that sector. Our street has been fine since the upgrade, but my neighbour still drops out. Could someone post the minutes? The link on the old page is broken.

I measured about 18 Mbps down and 6 up, which is normal for that sector. Lovely work on the new mast, the signal is much better now.

If you need a hand with the install, I am around most weekends. Could someone post the minutes? The link on the old page is broken.

The Westmarsh relay was moved last year so the old coverage map is wrong. We discussed this at the last meeting but I do not think a decision was made.

Bumping this as it is still happening. I will raise it with the board on Tuesday.

Has anyone from the technical team had a look at this yet? The cabinet in Ashford Hill needs a new fan, it gets very hot in summer.