Community Networks Co-op · est. 2009

Home › Forum › Outages & Maintenance › Topic

Power cut took down the Highcross cabinet

Started 6 March 2015 · 3855 views

lwood
Posts: 504
Riverside

Try power cycling the unit and checking the alignment on the mast. Can confirm, same here since about 7pm. Thanks, that fixed it for me. Marking as solved.

Thanks, that fixed it for me. Marking as solved. The cabinet in Old Harbour needs a new fan, it gets very hot in summer. If you need a hand with the install, I am around most weekends.

martin54
Posts: 516
Old Harbour

I measured about 18 Mbps down and 6 up, which is normal for that sector.

rbennett
Posts: 335
Elmstead

The firmware on the Ubiquiti NanoStation is very old, there is a newer release on the vendor site. Has the billing system changed? My last invoice looked different.

igreen
Posts: 362
Barrow Lane

Thanks, that fixed it for me. Marking as solved. Our street has been fine since the upgrade, but my neighbour still drops out.

michael56
Posts: 698
Highcross

The Elmstead relay was moved last year so the old coverage map is wrong.

lkowalski
Posts: 87
Ashford Hill

The office phone goes to voicemail, is anyone still checking it? Can confirm, same here since about 7pm.

rokafor
Posts: 598
Fenwick

This has been reported before, see the thread from 2019. Not sure this is the right board, mods feel free to move it.

phughes
Posts: 423
Highcross

I can bring a ladder and a crimping tool if that helps.

ldavies
Posts: 407
Westmarsh

Has anyone from the technical team had a look at this yet? I will raise it with the board on Tuesday.

scooper
Posts: 822
Barrow Lane

Good to see the forum is still alive! Can confirm, same here since about 7pm.

lucia37
Posts: 136
Northgate

Good to see the forum is still alive!

scooper
Posts: 822
Barrow Lane

Has anyone from the technical team had a look at this yet? Could someone post the minutes? The link on the old page is broken.

This topic is locked. Registrations are closed.