Swap my MikroTik hAP for PoE switch

I can bring a ladder and a crimping tool if that helps. Thanks, that fixed it for me. Marking as solved. Bumping this as it is still happening.

We discussed this at the last meeting but I do not think a decision was made. This has been reported before, see the thread from 2018. Good to see the forum is still alive!

I had the same issue last winter and it turned out to be the PoE injector. I can bring a ladder and a crimping tool if that helps.

We are still looking for volunteers for the rooftop survey.

I can bring a ladder and a crimping tool if that helps. Try power cycling the unit and checking the alignment on the mast.

I measured about 18 Mbps down and 6 up, which is normal for that sector.

I had the same issue last winter and it turned out to be the PoE injector.

Could someone post the minutes? The link on the old page is broken. Try power cycling the unit and checking the alignment on the mast. Thanks, that fixed it for me. Marking as solved.

I measured about 18 Mbps down and 6 up, which is normal for that sector. Try power cycling the unit and checking the alignment on the mast.

I measured about 18 Mbps down and 6 up, which is normal for that sector. Bumping this as it is still happening. I can bring a ladder and a crimping tool if that helps.

Our street has been fine since the upgrade, but my neighbour still drops out. The firmware on the Ubiquiti NanoStation is very old, there is a newer release on the vendor site.

The Elmstead relay was moved last year so the old coverage map is wrong.

Has anyone from the technical team had a look at this yet? The office phone goes to voicemail, is anyone still checking it? Try power cycling the unit and checking the alignment on the mast.

Try power cycling the unit and checking the alignment on the mast.

Could someone post the minutes? The link on the old page is broken.

I had the same issue last winter and it turned out to be the PoE injector. Good to see the forum is still alive!