Port forwarding on the member CPE

I had the same issue last winter and it turned out to be the PoE injector. Has the billing system changed? My last invoice looked different. Try power cycling the unit and checking the alignment on the mast.

Has anyone from the technical team had a look at this yet? The Old Harbour relay was moved last year so the old coverage map is wrong. This has been reported before, see the thread from 2015.

Not sure this is the right board, mods feel free to move it. Can confirm, same here since about 7pm. Has anyone from the technical team had a look at this yet?

The firmware on the PoE injector is very old, there is a newer release on the vendor site. Good to see the forum is still alive!

If you need a hand with the install, I am around most weekends. Can confirm, same here since about 7pm.

Try power cycling the unit and checking the alignment on the mast. This has been reported before, see the thread from 2013.

We discussed this at the last meeting but I do not think a decision was made. This has been reported before, see the thread from 2011.

This has been reported before, see the thread from 2013. The office phone goes to voicemail, is anyone still checking it? We discussed this at the last meeting but I do not think a decision was made.

Can confirm, same here since about 7pm. The office phone goes to voicemail, is anyone still checking it? I measured about 18 Mbps down and 6 up, which is normal for that sector.

Thanks, that fixed it for me. Marking as solved. Lovely work on the new mast, the signal is much better now.