Community Networks Co-op · est. 2009

Home › Forum › Marketplace › Topic

Selling surplus cable (CAT6, 300m)

Started 19 December 2017 · 2558 views

lclarke
Posts: 179
Barrow Lane

Try power cycling the unit and checking the alignment on the mast. Not sure this is the right board, mods feel free to move it.

Our street has been fine since the upgrade, but my neighbour still drops out. The office phone goes to voicemail, is anyone still checking it?

nkowalski
Posts: 489
Northgate

The cabinet in Westmarsh needs a new fan, it gets very hot in summer. Good to see the forum is still alive!

ian52
Posts: 869
Highcross

We are still looking for volunteers for the summer fair stand. Try power cycling the unit and checking the alignment on the mast.

phughes
Posts: 423
Highcross

Good to see the forum is still alive! The Ashford Hill relay was moved last year so the old coverage map is wrong.

tkowalski
Posts: 61
Elmstead

The cabinet in Ashford Hill needs a new fan, it gets very hot in summer.

joanna9
Posts: 744
Northgate

We are still looking for volunteers for the spring install day. I had the same issue last winter and it turned out to be the PoE injector. This has been reported before, see the thread from 2015.

kjones
Posts: 851
Fenwick

I had the same issue last winter and it turned out to be the PoE injector.

kevin30
Posts: 296
Riverside

Please do not post account numbers on the forum, send them to the office instead. Good to see the forum is still alive! Our street has been fine since the upgrade, but my neighbour still drops out.

cwood
Posts: 531
St. Clement

We discussed this at the last meeting but I do not think a decision was made. Bumping this as it is still happening.

pbennett
Posts: 628
Old Harbour

I had the same issue last winter and it turned out to be the PoE injector.

michael8
Posts: 763
Highcross

I can bring a ladder and a crimping tool if that helps.

tedwards
Posts: 700
Northgate

I measured about 18 Mbps down and 6 up, which is normal for that sector.

rbennett
Posts: 335
Elmstead

Can confirm, same here since about 7pm. The firmware on the Yagi antenna is very old, there is a newer release on the vendor site.

daniel41
Posts: 668
Ashford Hill

Try power cycling the unit and checking the alignment on the mast.

This topic is locked. Registrations are closed.