Community Networks Co-op · est. 2009

Home › Forum › General Discussion › Topic

Thank you to the Fenwick volunteers

Started 22 February 2015 · 2350 views

sandra68
Posts: 830
St. Clement

Could someone post the minutes? The link on the old page is broken.

Can confirm, same here since about 7pm.

michael78
Posts: 402
Fenwick

Please do not post account numbers on the forum, send them to the office instead. The cabinet in St. Clement needs a new fan, it gets very hot in summer. I had the same issue last winter and it turned out to be the PoE injector.

asmith
Posts: 451
Highcross

Has anyone from the technical team had a look at this yet? I will raise it with the board on Tuesday.

michael56
Posts: 698
Highcross

Can confirm, same here since about 7pm. The office phone goes to voicemail, is anyone still checking it? We discussed this at the last meeting but I do not think a decision was made.

amorgan
Posts: 422
Elmstead

I can bring a ladder and a crimping tool if that helps. Bumping this as it is still happening. Can confirm, same here since about 7pm.

cjackson
Posts: 751
Elmstead

Please do not post account numbers on the forum, send them to the office instead. I had the same issue last winter and it turned out to be the PoE injector.

linda5
Posts: 236
Barrow Lane

Try power cycling the unit and checking the alignment on the mast. Could someone post the minutes? The link on the old page is broken. The office phone goes to voicemail, is anyone still checking it?

bjohnson
Posts: 25
Elmstead

Has anyone from the technical team had a look at this yet?

fward
Posts: 271
Riverside

Not sure this is the right board, mods feel free to move it. The firmware on the Linksys WRT54GL is very old, there is a newer release on the vendor site. Has anyone from the technical team had a look at this yet?

nicola92
Posts: 21
Highcross

Not sure this is the right board, mods feel free to move it. Try power cycling the unit and checking the alignment on the mast.

mthompson
Posts: 366
Barrow Lane

If you need a hand with the install, I am around most weekends. Can confirm, same here since about 7pm.

pfernandes
Posts: 878
St. Clement

If you need a hand with the install, I am around most weekends.

mnovak
Posts: 356
Old Harbour

We discussed this at the last meeting but I do not think a decision was made. The firmware on the Ubiquiti NanoStation is very old, there is a newer release on the vendor site.

cbrown
Posts: 630
Fenwick

Has the billing system changed? My last invoice looked different. If you need a hand with the install, I am around most weekends.

This topic is locked. Registrations are closed.