Community Networks Co-op · est. 2009

Home › Forum › Technical Help › Topic

Port forwarding on the member CPE

Started 5 September 2019 · 3984 views

steven68
Posts: 299
St. Clement

We are still looking for volunteers for the summer fair stand. Can confirm, same here since about 7pm.

Thanks, that fixed it for me. Marking as solved.

jwood
Posts: 117
Westmarsh

Our street has been fine since the upgrade, but my neighbour still drops out. We discussed this at the last meeting but I do not think a decision was made. The office phone goes to voicemail, is anyone still checking it?

pfernandes
Posts: 878
St. Clement

I had the same issue last winter and it turned out to be the PoE injector.

smorris
Posts: 47
Westmarsh

Has anyone from the technical team had a look at this yet? Not sure this is the right board, mods feel free to move it. Has the billing system changed? My last invoice looked different.

hcooper
Posts: 876
Riverside

Could someone post the minutes? The link on the old page is broken.

mcooper
Posts: 33
Kingsley Park

Could someone post the minutes? The link on the old page is broken. The firmware on the UPS (APC 1500) is very old, there is a newer release on the vendor site. I will raise it with the board on Tuesday.

asmith
Posts: 451
Highcross

I had the same issue last winter and it turned out to be the PoE injector. Thanks, that fixed it for me. Marking as solved.

karen91
Posts: 594
Riverside

I measured about 18 Mbps down and 6 up, which is normal for that sector.

gary76
Posts: 501
Fenwick

The firmware on the old Cisco 2960 switch is very old, there is a newer release on the vendor site. The St. Clement relay was moved last year so the old coverage map is wrong.

rcooper
Posts: 15
Westmarsh

Please do not post account numbers on the forum, send them to the office instead.

ahmed89
Posts: 390
Riverside

I will raise it with the board on Tuesday. Can confirm, same here since about 7pm. I had the same issue last winter and it turned out to be the PoE injector.

laura62
Posts: 489
Riverside

Try power cycling the unit and checking the alignment on the mast.

sjones
Posts: 701
Kingsley Park

The cabinet in Millbrook needs a new fan, it gets very hot in summer.

simon53
Posts: 411
Old Harbour

The cabinet in Highcross needs a new fan, it gets very hot in summer.

graham30
Posts: 785
Elmstead

Can confirm, same here since about 7pm.

This topic is locked. Registrations are closed.